Riverside Machinery has unveiled a range of crusher buckets designed to work with any excavator available in the marketplace. There are three models – the CB160, CB260 and CB410.

The CB410 can crush up to 45m3 of material in an hour, the CB260 35m3 and the CB60 25m3.

Superior Crushing Action

Powered by the excavator's standard hydraulic breaker circuit, the LST crusher bucket uses a fixed jaw and a hydraulically driven moving jaw. The gap between the two jaws can be set with shims to determine the size of the finished material.

The crushing action is achieved by the moving jaw being cycled in and out using an eccentric shaft. This shaft is equipped with flywheels at each end and rotated by a belt from the hydraulic motor.

Total Versatility

The CB160 is designed to work with 8 - 14 Tonne Excavators and has a capacity 0.5m3. The CB260 is designed to work with 18 - 25 Tonne Excavators and has a capacity of 0.6m3. The CB410 is designed to work with 24 - 47 Tonne Excavators and has a capacity of 0.9m3.

The LST crushing bucket is also ideally suited to work on sites where normally a licence is required for a mobile crusher.

Crusher buckets are designed to reduce site waste, brick, demolition rubble or rock into a usable material, eliminating haulage and disposal costs. The LST range of crusher buckets has a closed side setting of 20mm - 120mm

Heavy Duty Engineering

LST Crushing Buckets are manufactured wholly in Germany to a very high level of engineering offering you the customer robust performance and low running costs.

http://www.hub-4.com/news/2856/riverside-machinery-launch-range-of-crushing-buckets-from-lst-attachments